Using the IP Range Tab in Views

When you install SecureAnywhere on endpoints, the agent runs an initial scan to report the endpoint status and gather information to identify it in the Management Portal. Once these endpoints report back to the Management Console, you can then view the data collected by the agent in the Views tab under Group Management.

For more information see Using the Activity Directory Tab in Views and Using the Workgroup Tab in Views.

To view the IP Range lists in the Management Portal:

1. Click the Group Management tab.
2. On the left, click the Views tab, then click the IP Range tab.

   

3. From here you can view your endpoints by their IP Range.

   Note: The endpoints listed here cannot be moved as the organization is based on the data collected by the agent on its last scan. This information will change if the data is different on any subsequent scan.

4. You can also send commands and change the polices to the endpoints listed. You can only send these changes by individual endpoint or page, not by the entire view.

   Note: You can select all endpoints on the page within the selected view by selecting the Hostname checkbox at the top of the list.